Interlogix NS3502-8P-2S User Manual - Manual (Page 85)

IFS NS3502-8P-2S User Manual
85
SNMP v2c: Set SNMP trap supported version 2c.
SNMP v3: Set SNMP trap supported version 3.
• Trap Community Indicates the community access string when send SNMP trap
packet. The allowed string length is 0 to 255, and the allowed
content is the ASCII characters from 33 to 126.
• Trap Destination
Address Indicates the SNMP trap destination address.
• Trap Destination
IPv6 Address
Provide the trap destination IPv6 address of this switch. IPv6
address is in 128-bit records represented as eight fields of up to
four hexadecimal digits with a colon separate each field (:). For
example,
‘fae0::013:4fefe:dea4:34d4’ . The symbol '::' is a special
syntax that can be used as a shorthand way of representing
multiple 16-bit groups of contiguous zeros; but it can only appear
once. It also used a following legally IPv4 address. For example,
'::192.1.2.34'.
• Trap
Authentication
Failure Indicates the SNMP entity is permitted to generate
authentication failure traps. Possible modes are:
Enabled: Enable SNMP trap authentication failure.
Disabled: Disable SNMP trap authentication failure.
• Trap Link-up and
Link-down
Indicates the SNMP trap link-up and link-down mode operation.
Possible modes are:
Enabled: Enable SNMP trap link-up and link-down mode
operation.
Disabled: Disable SNMP trap link-up and link-down mode
operation.
• Trap Inform Mode Indicates the SNMP trap inform mode operation. Possible modes
are:
Enabled: Enable SNMP trap inform mode operation.
Disabled: Disable SNMP trap inform mode operation.
• Trap Inform
Timeout (seconds)
Indicates the SNMP trap inform timeout. The allowed range is 0
to 2147.
• Trap Inform Retry
Times
Indicates the SNMP trap informs retry times. The allowed range is
0 to 255.
Buttons
: Click to save changes.
: Click to undo any changes made locally and revert to previously saved values.