Interlogix NS3502-8P-2S User Manual - Manual (Page 330)

IFS NS3502-8P-2S User Manual
330
Profile4
• AF/AT Mode Allows user to select 802.3at or 802.3af compatibility mode. The
default value is 802.3at mode. This function will affect PoE power
reservation on Classification power limit mode only, as 802.3af
mode, system is going to reserve 15.4W maximum for PD that
supported Class3 level. As IEEE 802.3at mode, system is going to
reserve 30.8Watts for PD that support Class4 level. From class1
to class3 level on the 802.3at mode will be reserved the same
PoE power with 802.3af mode.
• Priority The Priority represents PoE ports priority. There are three levels
of power priority named Low, High and Critical.
The priority is used in the case when total power consumption
has been over total power budget. In this case the port with the
lowest priority will be turn off, and offer power for the port of
higher priority.
• Maximum Power The Maximum Power value contains a numerical value that
indicates the maximum power in watts that can be delivered to
a remote device.
Per port maximum value must less than 30.8 watts, total ports
values must less than the Power Reservation value.
Once power overload detected, the port will auto shut down
and keep on detection mode until PD’s power consumption
lower than the power limit value.
• Power Allocation It can limit the port PoE supply watts. Per port maximum value
must less than 30.8 watts, total ports values must less than the
Power Reservation value. Once power overload detected, the
port will auto shut down and keep on detection mode until PD’s
power consumption lower than the power limit value
Buttons
: Click to save changes.
: Click to undo any changes made locally and revert to previously saved values.