Interlogix NS3502-8P-2S User Manual - Manual (Page 281)

IFS NS3502-8P-2S User Manual
281
4.12.4 HTTPs
Configure HTTPS on this page. The HTTPS Configuration screen in Figure 4-12-4 appears.
Figure 4-12-4: HTTPS Configuration screen page screenshot
The page includes the following fields:
Object Description
• Mode Indicates the HTTPS mode operation. Possible modes are:
Enabled: Enable HTTPS mode operation.
Disabled: Disable HTTPS mode operation.
• Automatic Redirect Indicates the HTTPS redirect mode operation. Automatic redirect
web browser to HTTPS during HTTPS mode enabled. Possible
modes are:
Enabled: Enable HTTPS redirect mode operation.
Disabled: Disable HTTPS redirect mode operation.
Buttons
: Click to save changes.
: Click to undo any changes made locally and revert to previously saved values.
4.12.5 SSH
Configure SSH on this page. This page shows the Port Security status. Port Security is a module with no
direct configuration. Configuration comes indirectly from other modules - the user modules. When a
user module has enabled port security on a port, the port is set-up for software-based learning. In this
mode, frames from unknown MAC addresses are passed on to the port security module, which in turn
asks all user modules whether to allow this new MAC address to forward or block it. For a MAC address
to be set in the forwarding state, all enabled user modules must unanimously agree on allowing the
MAC address to forward. If only one chooses to block it, it will be blocked until that user module
decides otherwise.