Interlogix NS3502-8P-2S User Manual - Manual (Page 503)

IFS NS3502-8P-2S User Manual
503
disable : Set DSCP as un-trusted DSCP
(default: Show DSCP Trust status)
Default Setting:
disable
QoS DSCP Classification Mode
Description:
Set or show DSCP ingress classification mode.
If port DSCP classification is 'selected', DSCP will be classified based on QoS class and DP level
only for DSCP value with classification mode 'enabled'. DSCP may be translated DSCP if
translation is enabled for the port.
Syntax:
QoS DSCP Classification Mode [] [enable|disable]
Parameters:
: DSCP (0-63, BE, CS1-CS7, EF or AF11-AF43) list or 'all'
enable : Enable DSCP ingress classification
disable : Disable DSCP ingress classification
(default: Show DSCP classification mode)
Default Setting:
disable
QoS DSCP EgressRemap
Description:
Set or show DSCP egress remap table. This table is used if the port egress remarking mode is
'remap' and the purpose is to map the DSCP and DP level to a new DSCP value.
Syntax:
QoS DSCP EgressRemap [] [] []
Parameters:
: DSCP (0-63, BE, CS1-CS7, EF or AF11-AF43) list or 'all'
: DP level list or 'all', default: All DP levels (0-1)
: Egress remapped DSCP: 0-63, BE, CS1-CS7, EF or AF11-AF43