Interlogix NS3502-8P-2S User Manual - Manual (Page 238)

IFS NS3502-8P-2S User Manual
238
globally enable/disable Guest VLAN functionality. When checked,
the individual ports' ditto setting determines whether the port
can be moved into Guest VLAN. When unchecked, the ability to
move to the Guest VLAN is disabled for all ports.
• Guest VLAN ID This is the value that a port's Port VLAN ID is set to if a port is
moved into the Guest VLAN. It is only changeable if the Guest
VLAN option is globally enabled.
Valid values are in the range [1; 4095].
• Max. Reauth.
Count
The number of times that the switch transmits an EAPOL Request
Identity frame without response before considering entering the
Guest VLAN is adjusted with this setting. The value can only be
changed if the Guest VLAN option is globally enabled.
Valid values are in the range [1; 255].
• Allow Guest VLAN
if EAPOL Seen
The switch remembers if an EAPOL frame has been received on
the port for the life-time of the port. Once the switch considers
whether to enter the Guest VLAN, it will first check if this option
is enabled or disabled. If disabled (unchecked; default), the
switch will only enter the Guest VLAN if an EAPOL frame has not
been received on the port for the life-time of the port. If enabled
(checked), the switch will consider entering the Guest VLAN even
if an EAPOL frame has been received on the port for the life-time
of the port.
The value can only be changed if the Guest VLAN option is
globally enabled.
Port Configuration
The table has one row for each port on the selected switch in the stack and a number of columns,
which are:
Object Description
• Port The port number for which the configuration below applies.
• Admin State If NAS is globally enabled, this selection controls the port's
authentication mode. The following modes are available:
 Force Authorized
In this mode, the switch will send one EAPOL Success frame when
the port link comes up, and any client on the port will be allowed