Interlogix NS3502-8P-2S User Manual - Manual (Page 204)

IFS NS3502-8P-2S User Manual
204
4. SNAP
5. IPv4
6. IPv6
Note: all frame types are explained below.
• Any Allow all types of frames.
• Ethernet Ethernet Type Valid ethernet type can have value within
0x600-0xFFFF or 'Any' but excluding 0x800(IPv4) and 0x86DD
(IPv6), default value is 'Any'.
• LLC SSAP Address Valid SSAP(Source Service Access Point) can vary
from 0x00 to 0xFF or 'Any', the default value is 'Any'
DSAP Address Valid DSAP(Destination Service Access Point) can
vary from 0x00 to 0xFF or 'Any', the default value is 'Any'
Control Address Valid Control Address can vary from 0x00 to
0xFF or 'Any', the default value is 'Any'
• SNAP PID Valid PID(a.k.a ethernet type) can have value within
0x00-0xFFFF or 'Any', default value is 'Any'
• IPv4 Protocol IP protocol number: (0-255, TCP or UDP) or 'Any'
Source IP Specific Source IP address in value/mask format or
'Any'. IP and Mask are in the format x.y.z.w where x, y, z, and w
are decimal numbers between 0 and 255. When Mask is
converted to a 32-bit binary string and read from left to right, all
bits following the first zero must also be zero
DSCP Diffserv Code Point value (DSCP): It can be specific value,
range of value or 'Any'. DSCP values are in the range 0-63
including BE, CS1-CS7, EF or AF11-AF43
IP Fragment IPv4 frame fragmented option: yes|no|any
Sport Source TCP/UDP port:(0-65535) or 'Any', specific or port
range applicable for IP protocol UDP/TCP
Dport Destination TCP/UDP port:(0-65535) or 'Any', specific or
port range applicable for IP protocol UDP/TCP
• IPv6 Protocol IP protocol number: (0-255, TCP or UDP) or 'Any'
Source IP IPv6 source address: (a.b.c.d) or 'Any', 32 LS bits
DSCP Diffserv Code Point value(DSCP): It can be specific value,
range of value or 'Any'. DSCP values are in the range 0-63
including BE, CS1-CS7, EF or AF11-AF43
Sport Source TCP/UDP port:(0-65535) or 'Any', specific or port
range applicable for IP protocol UDP/TCP
Dport Destination TCP/UDP port:(0-65535) or 'Any', specific or
port range applicable for IP protocol UDP/TCP