2 access control list configuration – Interlogix NS3502-8P-2S User Manual User Manual
Page 213
IFS NS3502-8P-2S User Manual
213
ARP: The ACE will match ARP
IPv4: The ACE will match all IPv4 frames.
IPv
IPv
IPv
IPv4/Other: The ACE will match IPv4 frames, which are not
ICMP/UDP/TCP.
IPv6: The ACE will match all IPv6 standard frames.
• Action
Indicates the forwarding action of the ACE.
Permit: Frames matching the ACE may be forwarded and learned.
Deny: Frames matching the ACE are dropped.
• Rate Limiter
Indicates the rate limiter number of the ACE. The allowed range
is 1 to 16. When Disabled is displayed, the rate limiter operation
is disabled.
• Port Copy
Indicates the port copy operation of the ACE. Frames matching
the ACE are copied to the port number. The allowed values are
Disabled or a specific port number. When Disabled is displayed,
the port copy operation is disabled.
• CPU
Forward packet that matched the specific ACE to CPU.
• CPU Once
Forward first packet that matched the specific ACE to CPU.
• Counter
The counter indicates the number of times the ACE was hit by a
frame.
• Conflict
Indicates the hardware status of the specific ACE. The specific
ACE is not applied to the hardware due to hardware limitations.
Buttons
:
Select the ACL status from this drop down list.
Auto-refresh : Check this box to refresh the page automatically. Automatic refresh occurs at regular
intervals.
: Click to refresh the page; any changes made locally will be undone.
4.10.2 Access Control List Configuration
This page shows the Access Control List
Each row describes the ACE that is defined. The maximum number of ACEs is 256 on each switch.
Click on the lowest plus sign to add a new ACE to the list. The reserved ACEs used for internal protocol,
cannot be edited or deleted, the order sequence cannot be changed and the priority is highest.