Interlogix NS3502-8P-2S User Manual - Manual (Page 176)

IFS NS3502-8P-2S User Manual
176
• MLD Querier Enable the MLD Querier in the VLAN.
• RV Robustness Variable. The Robustness Variable allows tuning for
the expected packet loss on a link. The allowed range is 1 to 255,
default robustness variable value is 2.
• QI Query Interval. The Query Interval variable denotes the interval
between General Queries sent by the Querier. The allowed range
is 1 to 255 seconds; default query interval is 125 seconds.
• QRI Query Response Interval. The Maximum Response Delay used to
calculate the Maximum Response Code inserted into the periodic
General Queries. The allowed range is 0 to 31744 in tenths of
seconds; default query response interval is 100 in tenths of
seconds (10 seconds).
• LLQI Last Listener Query Interval. The Last Listener Query Interval is
the Maximum Response Delay used to calculate the Maximum
Response Code inserted into Multicast Address Specific Queries
sent in response to Version 1 Multicast Listener Done messages.
It is also the Maximum Response Delay used to calculate the
Maximum Response Code inserted into Multicast Address and
Source Specific Query messages. The allowed range is 0 to 31744
in tenths of seconds; default last listener query interval is 10 in
tenths of seconds (1 second).
• URI Unsolicited Report Interval. The Unsolicited Report Interval is the
time between repetitions of a node's initial report of interest in a
multicast address. The allowed range is 0 to 31744 seconds,
default unsolicited report interval is 1 second.
Buttons
: Refreshes the displayed table starting from the "VLAN" input fields.
: Updates the table starting from the first entry in the VLAN Table, i.e. the entry with the lowest
VLAN ID.
: Updates the table, starting with the entry after the last entry currently displayed.
: Click to save changes.
: Click to undo any changes made locally and revert to previously saved values.