EVCO c-pro kilo AHU - Manual (Page 28)

C-PRO KILO AHU APPLICATION MANUAL
Pag. 28
The following page summarizes the main values pertaining to the regulation of the delivery
temperature:
The following page summarizes the main values pertaining to the regulation of humidity:
Note. If certain devices are disabled, the information contained in the parameters for that
particular devices operating status will be substituted by dots (“....”) in order to exclude
information pertaining to any disabled devices from being stored in the status pages. The
same applies for probes which are disabled.
4.2.11 Alarm pages
In order to view the alarms, choose ALARMI (ALARMS) from the general Menu or,
alternatively, from the main pages by pressing ESC to view the following page:
You can press ENTER on “Mostra ALARMI >>”(Show Alarms >>).
If no alarms are present you will see written“NO ALARMI”(NO ALARMS), otherwise, each
time you press ENTER you will view the next active alarm, and so forth.
By pressing the ENTER key for approximately 2 seconds, you will restore the alarms in the
case where the condition of error was restored. If this were not true, the current mask would
remain in view. If from one alarm page you press the ESC key or if you wait for a 60 second
timeout period, you will be brought back to the main page of the application. This level is not
password protected.
Value of delivery probe and regulation Set Point
Requested heating (and cooling in the case where a
single coil is used) and actual Set Point for heating
Requested cooling and actual Set Point for cooling
Value of ambient humidity probe and regulation Set Point
Requested humidification and and actual humidification
Set Point
Requested dehumidification and actual dehumidification Set
Point