Toshiba LF494 - Manual (Page 93)

TOSHIBA
6 . F 8 A 0 7 7 4 ,
■ To change the password;
The following example shows how (o change the password from 123 mm to 453 mm.
Key operalJott Display example Description
SHI
□
A4; PASSWORD
123
Press [SH f] first to start the items selection
sequence and select A4: PASSWORD from among the
configuration ilcms using [ ► ] and [ a . ] keys. Press
[SET] again lo display the current password (123 in
ihííj example).
Case of inputting wrong password in Ihc
password input mode, the current password
doesn't appear, but “***” appears.
►
□ A4: PASSVORD
123
Pressing [ ► ], the cursor appears. Then press [ ► ]
as many times as necessary to move the cursor to digit
to be changed.
A ►
A4: PASSWORD
423
453
Change the value by pressing [ a . ], Then move the
cursor lo another digit by pressing [ ► ] and change
the value. In this example repeat this process uniiJ the
display shows *‘453’’ (Note)
SET
A4: PASSWORD
456
Pressing [SET], the cursor disappears and the changed
display flickers. Press [SRT] again lo save the value.
SET
□ M; PASSWORD
Pressing [SET], the system returns to the items sc-
lecUoji sequence.
Note;
1. Setting ‘‘iXXJ"’ [o the password, passwmd input mode doesn’t appear and ei 11
configuration parameter and calibrate can be changed.
2, If passsword is set, do not forget the password. In case of forgetting password,
refer to next page, readoul the password, But the administrEttion, including
the way to readout password,
The method of PASSWORD MA^AGLMH^”1’ including its lifting or reading out requires
to be controlled hy our system's ow^n ri^jk.
-
92
-