Safety precautions (continued), Safety precautions for maintenance and inspection, Caution – Toshiba LF494 User Manual
Page 5: Toshiba
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

TOSHIBA
6 F , 8 A 0 7 7 4
SAFETY PRECAUTIONS (continued)
Safety Precautions for Maintenance and Inspection
CAUTION
■
Turn off mains power before
conducting wiring work.
Wiring while power is ap-
plied can cause electric shock,
DO
■ Ground the LF494/LF404 indepen
dently from power equipment,
Operating this product without
^^9
grounding can cause electric
shock or mal fu net ion.
■ Do not condnet wiring work with bare
■ Use compression terminal lugs with
hands.
insulation
sleeve for the termmul
Remaining electric charge
block and GND terminal.
Loose connections can cause
electric shock, fire from
excessive current or system
I
even if power is turned off
can still cause electric shock.
DON’T
malfunction.
■ Do not work on piping and wiring w ith
The label shown left is placed
wet hands.
near the terminal board for
Wet hands may result in
^|\
pow'cr input.
/ J \
(A black border and symbol on
f J
electric shock.
DON’T
yellow triangle)
Be alert to electric shock.
■
Do not touch the flowmeter main
■ Do not conduct wiring work when
body when high temperature fluid is
power is applied.
being measured.
The fluid raises the main
y^“V Wiring while power is applied
i
can cause electric shock.
i
body temperature and can
cause burns when toucheil.
DON’T
DON’T
■
Do not conduct wiring work with wet
The label shown left is placed
hands.
yy neaj ihe icrininal board for
1
Wet hands may result in
/w\^
power input.
/
(A black border and symbol on
electric shock.
yellow triangle)
DON’T
Be alert to eleciric shock.
■ Do not use a fuse other than the one
Use a rated fu.se as follow^]
¡»pvcifled.
Fuse rating:
Using a fuse other than the
* 1 A;250V for 100 to 24t)Vacor llOVdc
\
one specified can cause
• 2A^250V for 24 V dc
V,
;V
system failure, damage or
Dimensions:
mal ft! action.
Diameter 5.2 inm x 20 mm
DON’T
Melting time characteristic:
Normal blow |
Disclaimer
Toshiba does noi 9ccep[ liitbility for any dsimagc or loss, msuerial or personal, caused its a
direct or indirect result of the operation of this product in connection with, or due to, the
occurrence of any event of force majeurc (including fire or earthquake) or the misuse of
this product, whether iutcntiounl or aeddentaJ.
-
4
-