5a2 cable connections, Note, Toshiba – Toshiba LF494 User Manual
Page 30
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

TOSHIBA
6 F 8 A 0 7 7 4
5A2
Cable Connections
Connect the term incited cable wires to the terminal board as described below.
IMPORTANT
Connect the wires securely to :hc terminal board. A loose connection may result in
unsaiisfacLory flowmeter performance. Make sure the wires arc securely connected.
(J) Remove the housing cover for the terminal board shown in Figure 3.1. The terminal board
is located inside the converter as shown in Figure 3,2. Connect the crimped terminal of
each wire to the specified pin of the terminal board . See Figure 5.1 for the terminal board
configuration, Tighten each crimped terminal to the terminal board wiih a screw using a
l*hil!ips screwdriver as shown in Figure 5.6. Loose connection may result in unsatisfactory
flowmeter performance. Make sure the wire is securely connected.
NOTE
ITic appropriate torque for tightening the terminal board screws is J .2 Ntn (12 kgf- cm).
(2) After the terminal block connecriorij pull the cable a little so that the cable runs straight
from (he terminal block without unnecessary winding.
(3) Attach the terminal cover and screw the housing cover for the terminal block. To keep the
housing seal, lighten securely the cover using a tool fitting with the groove on the cover
- 2 & -