Toshiba – Toshiba LF494 User Manual
Page 67
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
TOSHIBA
6 F 8 A 0 . 7 7 4
Ta change the Jow cutoff value:
The following example shows how to change the low cutoff value from 1.0 to 3,0 %.
Key operation
Di$play example
Deiicriptlon
SET
□
D l :
LOW CUT
0 1 . 0
%
Press [SETj first to start the items Hclcction sequence
jnd select D2: LOW CUT from among the
configuration items using [ ► ] and [ ^ | keys. Press
[SET] again to display the current low cutoff value
iT,0% in this example).
►
□
D2: LOW CUT
01.0 51
Pressing [ ► ], the cursor appears. T hen press [ ► ] to
move the cursor to the digit to be changed.
▲
□
D2: LOW CUT
03.
0
%
Change the value to *‘3” by pressing [
a
] twice* (Note)
(If necessary* move the cursor to another digit by
pressing [ ► ] and change the value.)
ST-r
□
DZ: LOW CUT
03.0
%
Pressing [SET], the cursor disappears and the changed
display nickers. Press [SET] again to store the value.
SET
□
02: LOW CUT
Pressing [SETj* the system returns to the ilems
selection sequence.
Note: If you try to set the low' cutoff value above 10
%
of ihe span, an error message
i H, OVER SPEC appears. Set the value w'ithin the specified range.
- 66 -