Preset point output performance(3), Toshiba – Toshiba LF494 User Manual
Page 125
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

TOSHIBA
6 F 8 A 0 7 7 4
■ Preset point output performance(3)
The following is example for preset point oulpul (pulse oul mode )
Note: Only In case of the a>nverier for special specifications (refer lo
7 3 3
‘*Converier for
Special specifications”), this preset point output (one shot pulse mode) can t>e selected
Selling preset counidOO
Totalizer
flow counts
Preset poini output
P'or it lakes the lime selted pulse
width from the output goes ON
200
100
ON
OFF
• The preset point output goes ON when the total i/cr counts reaches the preset point (UJO in
this example). And the next preset point (2ÜÜ in this example ; curreni preset point :100 and
preset count
:100
makes
200
) issetted* In this example repent this process ,
• The output goes OFF when it takes the lime setted pulse width from the output goes ON,
NOTE:
[f preset pulse is setted and preset pulse width is longer than the interval of that totalizer
reaches the preset point, the output can’t be form pulse oul,
If pulse output is needed, set preset cxjuiU according lo shown below.
Preset Pulse
The interval of
I’xample) Count rate:0,t)l 1
Width
that Totalizer reaches
Flow' verosity
:10
(■'^s
the Preset Point
Totalizer count up rate
:1
mS'^COUNT
50nis
More than liMJms
Preset Count:more than 100
“iOOms
More than lOtlOms
Preset Count;more than 1000
-
1 2 4
-