To change the meter ssize, Important, Toshiba – Toshiba LF494 User Manual
Page 49
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
TOSHIBA
6 F 8 A 0 7 7 4 ,
To change the meter ssize:
IMPORTANT
Meter sii^e iii 1 actory set when shipped. Do not change the meter size unless it differs
from the specified value.
The following example shows how lo change The meter size from 5f) mm to 100 mm.
Key operation
Display example
Description
SET
□
A2; METER SIZE
50 nur
Press [SET| first to start the uems selection
sequence and select A2: METERSIZE from among
the configuration items using [ ► ]and[A]keys.
Press [SET] again to display the current meter size
fSO mm ill this e.xample).
□
M :
METER SIZE
50 nut
Pressing [ ► ], the cursor apijcars.
▲
□
AZ: METER SIZE
100
inin
Select "‘100 mm” by pressing [
a
] as many times
as necessary. (Note)
SET
□
K Z \
METER SIZE
100
mm
Pressing [SET], the cursor disappears and the changed
display flickers. Press [SET] again to save the value.
SET
n
AZ: METER SIZE
Pressing [SET], the system relurns to the items
selection sequence.
c:
Note: The meter size is changed as shown below by pressing [
a
],
2.5 mm 15 mm “► 100 iiiin
f^iXl mm —►0.1 in 0,5 in^4 in • 24 in
□
Tf the meter size has been changed, other setting values (such as span and counting rate)
will be affected depending on the measuring unit u.sed. therefore, check those setting
values if you have changed the meter size,
-
43