10,6 preset point output, Toshiba – Toshiba LF494 User Manual
Page 122
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

TOSHIBA
6 F 8 A 0 7 7 4
10,6
Preset
Point Output
Using [his preset point output function, you can output
u
txjntact signal when the toiulized
How readies its preset value. Proceed as follows to u.sc this function.
TotaliTirsctting
Sot necessary parameters and selections to use the totalizer. See 10,2» “Totalizer and
Pulse Output.''
Preset value setting
Set the desired preset value. See 8.2.1
[ ,
"‘Preset Count Value.” ,
In case of the convener for special specifications (refer to 73 J “Converter for
Special specifications”), select the desired preset point output function.
8.2.20/’Pre,set Inunction”
DO/Dl function setciag
Set DOl or D02 for use as a preset point output. Sec 8.2.9, “Digital I/O”
To clear (reset) the totalizer with an external signal, sei DI as a Reset/Start signal,
in case of the converter for iipecial specifications (refer to 7.3.3 "Convertor for
Special specifications”), select Digital Input Detective Level. 8,2.19 ^"DI detective
Uvel”
If you use the control keys on the panel (optional) to dear (reset) the totalizer, this
setting is not needed.
- 1 2 1 -