Toshiba LF494 - Manual (Page 85)

TOSHIBA
6 F 8 A 0 7 7 4 .
To change the ratc-of'Change Hmit value:
The following example shows how lo change the rate-of-change Jimil value from JiU)
%
to
15.0 %.
Key operation Display example Description
SET
□
K1: L I M I T RATE
10
.
0
%
Press [SE'F] first to start the items selection sequence
and select Kl: LIMIT RATE from among the con­
figuration items using [ ► ] and [
^
) keys. Then
pre.ss [SET] again to display the current
rate-of“change Jimit value (10.0
%
in this exumpJe).
□ K1: L I M I T RATE
10
.
0
*
Pressing [ ► ], the cursor appears, Then press [ ► ] as
many times as necessary ro move the cursor ю the digit
to be changed.
▲
K1: L I M I T RATE
15,0
%
Change the value to "5’" by pressing [ ж ] five times.
(Note)
(U‘necessary, move the cursor to the next digit to be
changed by pressing [ ► ], and change the value.).
SET
□ K1: L I M I T RATE
15.
a
%
Pressing [SET], the cursor disappears and changed
rate-of-change limit value display flickers. Press [SET]
again io save the value.
SET K1: L I M I T RATE Pressing [SET], the system returns to the itetns selec­
tion sequence.
Note: If you try to set the value oat&ide the valid range» an error message * H. OVHR SPEC
appears. Set the value withir. the specified range.
To change the control limit time, se[;ct the item K2 : L I M I T TIME,
-
84
-