Toshiba LF494 - Manual (Page 52)

TOSHIBA
6 F 8 A 0 7 7 4
S.2.4 Indic^tting Unit
You can select one of the 29 engineering units lisled below as an indicating unil,
• Flow velocity: m/s, (ft/sj
• Flow rate: m-Vs, mVmin, mVd
l/s>
1
/min, i/h,
1
/d
mf/s» ml/minT ml/h, ml/d
(bbi/s), (hbJ/min), (bbl/h), (bbl/d)
(gal/s), (gal/min), (gdl/Ji), (gitl/d)
• Volumetric ilowi m^ I, ml, (gal)
(totalized flow)
• Other units:
% >
COL'NT (lotdlized flow wiihoul a unit), RANGE (1 to 4)
(• Code of volumetric
flow direction: F(fixcd forw ard flow)> R(fixcd reverse flow),
n(automa(ic selection bi-directional flow) )
Notes
L Units in parentheses, such as ‘W’, ‘"gal” and “ft” are shown only when the meter size is
selected in inches. They are nof sliown when the mcler size is selected in mm.
2. If COUNT or RANGE is selected, the display is shown as followii:
COUNT: displays totalized How counts
(8
digits) without a unit.
RANGE: displays the range njmbcr(l to 4).
3. Only in case of the converter for special specifications (refer to 7,3,3 “Converter for
Special specifications”),
•Time units /d, and flow rate uni is bbl/s, bbl/min, bbUh. bbl/d, bb( can be ,selected*
•Code of volutuctric flow direction F(fixed forward flow)^ R(fixed reverse flow),
ll(autoinaiic selection bi-dircctional flow) can be selected,
Two indicating unils (primary unit: UNIT 1, secondary unit: UNIT 2) can l?e selected.
Proceed as follows to check or change these two indicating units.
-
51
-