Toshiba LF494 - Manual (Page 91)

TOSHIBA
6 F 8 A 0 7 . 7 4
The following example shows how to change the zero offset value from
+lXi%
to
-2.5%^
: Key ope nit Inn Display example Description
'
SFI’
□
Ml: MANUAL ZERO
+001. Q%
PreiiS (SET] first to start the items selection sequence
atid select Ml: MANUAL ZERO from among llie
configuration items using
[ ► ] and [ a ] keys. Then
press [SET] again to display the current zero offset
value.
►
□ HI: MANUAL ZERO
+001. DSi
Pressing [ ► ]» the cursor appears.
(If necessary^ press [ ► ] as many times as
necessary to move the cursor to the desired digit to
change.)
▲
HI: MANUAL ZERO
lOOKO*
-002. 03C
-002. 5*
Change the sign code (“+" to by pressing [ a ].
Then move the cursor to another digit by pressing [ ► ]
and change the value, In this example repeat this process
until the display shows “-(XI2.5 (Note)
□
M1
:
MANUAL ZERO
-002. 5)i
Pressing [SET], the cursor disappears and the changed
value display flickers. Press [SET] again to save the
value.
SET
Ml : MANUAL ZERO Pressing [SET], the system returns to the setting
items selection sequence.
Note: [f you iry to set tite value above +0.125 m/s or below -(1,125 m/s, the error messages
t
H. OVER SPEC or* L OVER SPEC, respectively, appears.
Sei the value within ±0,125 m's.
- SO -