Kontron AT8402 CLI - Manual (Page 89)

AT8402 Switching Commands
Page 2 - 57 AT8402 CLI Reference Manual
2.13.1 monitor session
This command configures a probe port and a monitored port for monitor session (port
monitoring). Use the
source interface <
slot/port
>
parameter to specify the interface
to monitor. Use
rx
to monitor only ingress packets, or use
tx
to monitor only egress
packets. If you do not specify an
{rx | tx}
option, the destination port monitors both
ingress and egress packets. Use the
destination interface <
slot/port
>
to specify
the interface to receive the monitored traffic. Use the mode parameter to enabled the
administrative mode of the session. If enabled, the probe port monitors all the traffic
received and transmitted on the physical monitored port.
Format
monitor session
{source interface <slot/port> [{rx |
tx}] | destination interface <slot/port> | mode}
Mode Global Config
2.13.1.1 no monitor session
Use this command without optional parameters to remove the monitor session (port
monitoring) designation from the source probe port, the destination monitored port and
all VLANs. Once the port is removed from the VLAN, you must manually add the port
to any desired VLANs. Use the
source interface <
slot/port
>
parameter or
destination interface <
slot/port
>
to remove the specified interface from the port
monitoring session. Use the
mode
parameter to disable the administrative mode of the
session.
NOTE: Since the current version of FASTPATH software only supports one
session, if you do not supply optional parameters, the behavior of this
command is similar to the behavior of the
no monitor
command.
Format
no monitor session
[{source interface <slot/port> |
destination interface <slot/port> | mode}]
Mode Global Config
2.13.2 no monitor
This command removes all the source ports and a destination port for the and restores
the default value for mirroring session mode for all the configured sessions.
NOTE: This is a stand-alone “no” command. This command does not have a
“normal” form.
Default enabled
Format no monitor
Mode Global Config
2.13.3 show monitor session
This command displays the Port monitoring information for a particular mirroring
session.