Kontron AT8402 CLI - Manual (Page 78)

Switching Commands AT8402
AT8402 CLI Reference Manual Page 2 - 46
2.10.20 show dot1x users
This command displays 802.1x port security user information for locally configured
users.
Format show dot1x users < slot/port >
Mode Privileged EXEC
User Users configured locally to have access to the specified port.
2.10.21 show users authentication
This command displays all user and all authentication login information. It also
displays the authentication login list assigned to the default user.
Format
show users authentication
Mode Privileged EXEC
User Lists every user that has an authentication login list assigned.
System Login The authentication login list assigned to the user for system login.
802.1x Port Security The authentication login list assigned to the user for 802.1x port
security.
2.11 Storm-Control Commands
This section describes commands you use to configure storm control and view storm-
control configuration information. The Storm Control feature allows you to limit the
rate of specific types of packets through the switch on a per-port, per-type, basis. The
Storm Control feature can help maintain network performance.
2.11.1 storm-control broadcast
Use this command to enable broadcast storm recovery mode for a specific interface. If
the mode is enabled, broadcast storm recovery is active, and if the rate of L2 broadcast
traffic ingressing on an interface increases beyond the configured threshold, the traffic
will be dropped. Therefore, the rate of broadcast traffic will be limited to the
configured threshold.
Default disabled
Format
storm-control broadcast
Mode Interface Config
2.11.1.1 no storm-control broadcast
Use this command to disable broadcast storm recovery mode for a specific interface.
Format no storm-control broadcast
Mode Interface Config