Kontron AT8402 CLI - Manual (Page 167)

AT8402 Utility Commands
Page 4 - 27 AT8402 CLI Reference Manual
4.6 Keying for Advanced Features
This section describes the commands you use to enter the licence key to access
advanced features. You cannot access the advanced features without a valid license
key.
4.6.1 license advanced
This command enables a particular feature. This command also enables the
corresponding show commands for a feature.
NOTE: If the feature is enabled, the feature is visible in the output of the
show
running-config command. The parameter specifies the hexa-
decimal key for the feature.
Default none
Format
license advanced
Table 4.1. Copy Parameters
Source Destination Description
nvram:clibanner Copies the CLI banner to a server.
nvram:errorlog Copies the error log file to a server.
nvram:log Copies the log file to a server.
nvram:script name> Copies a specified configuration script
file to a server.
nvram:startup-config Copies the startup configuration to a
server.
nvram:traplog Copies the trap log file to a server.
system:running-config nvram:startup-config Saves the running configuration to
nvram.
nvram:clibanner Downloads the CLI banner to the sys-
tem.
nvram:script
Downloads a configuration script file to
the system. During the download of a
configuration script, the copy command
validates the script. In case of any error,
the command lists all the lines at the end
of the validation process and prompts
you to confirm before copying the script
file.
nvram:sshkey-dsa Downloads an SSH key file. For more
information, see 5.4 “Secure Shell (SSH)
Command“ on page 5 - 10.
nvram:sshkey-rsa1 Downloads an SSH key file.
nvram:sshkey-rsa2 Downloads an SSH key file.
nvram:startup-config Downloads the startup configuration file
to the system.