Kontron AT8402 CLI - Manual (Page 65)

AT8402 Switching Commands
Page 2 - 33 AT8402 CLI Reference Manual
Default 60
Format
set garp timer leave
<20-600>
Modes Interface Config
Global Config
2.7.2.1 no set garp timer leave
This command sets the GVRP leave time on all ports or a single port to the default and
only has an effect when GVRP is enabled.
Format
no set garp timer leave
Modes Interface Config
Global Config
2.7.3 set garp timer leaveall
This command sets how frequently Leave All PDUs are generated. A Leave All PDU
indicates that all registrations will be unregistered. Participants would need to rejoin in
order to maintain registration. The value applies per port and per GARP participation.
The time may range from 200 to 6000 (centiseconds). The value 1000 centiseconds is
10 seconds. You can use this command on all ports (Global Config mode) or a single
port (Interface Config mode), and it only has an effect only when GVRP is enabled.
Default 1000
Format
set garp timer leaveall
<200-6000>
Modes Interface Config
Global Config
2.7.3.1 no set garp timer leaveall
This command sets how frequently Leave All PDUs are generated the default and only
has an effect when GVRP is enabled.
Format
no set garp timer leaveall
Modes Interface Config
Global Config
2.7.4 show garp
This command displays GARP information.
Format
show garp
Modes Privileged EXEC
User EXEC
GMRP Admin Mode The administrative mode of GARP Multicast Registration Pro-
tocol (GMRP) for the system.
GVRP Admin Mode The administrative mode of GARP VLAN Registration Proto-
col (GVRP) for the system