Kontron AT8402 CLI - Manual (Page 208)

Management Commands AT8402
AT8402 CLI Reference Manual Page 5 - 18
5.6.8 snmp-server enable traps violation
This command enables the sending of new violation traps designating when a packet
with a disallowed MAC address is received on a locked port.
NOTE: For other port security commands, see 2.6 “Protected Ports Com-
mands” on page 2 - 30.
Default disabled
Format
snmp-server enable traps violation
Mode Interface Config
5.6.8.1 no snmp-server enable traps violation
This command disables the sending of new violation traps.
Format
no snmp-server enable traps violation
Mode Interface Config
5.6.9 snmp-server enable traps
This command enables the Authentication Flag.
Default
enabled
Format
snmp-server enable traps
Mode Global Config
5.6.9.1 no snmp-server enable traps
This command disables the Authentication Flag.
Format
no snmp-server enable traps
Mode Global Config
5.6.10 snmp-server enable traps bcaststorm
This command enables the broadcast storm trap. When enabled, broadcast storm traps
are sent only if the broadcast storm recovery mode setting associated with the port is
enabled.
Default
enabled
Format
snmp-server enable traps bcaststorm
Mode Global Config
5.6.10.1 no snmp-server enable traps bcaststorm
This command disables the broadcast storm trap. When enabled, broadcast storm traps
are sent only if the broadcast storm recovery mode setting associated with the port is
enabled.
Format
no snmp-server enable traps bcaststorm
Mode Global Config