Kontron AT8402 CLI - Manual (Page 214)

Management Commands AT8402
AT8402 CLI Reference Manual Page 5 - 24
5.8.1 radius accounting mode
This command is used to enable the RADIUS accounting function.
Default
disabled
Format
radius accounting mode
Mode Global Config
5.8.1.1 no radius accounting mode
This command is used to set the RADIUS accounting function to the default value - i.e.
the RADIUS accounting function is disabled.
Format
no radius accounting mode
Mode Global Config
5.8.2 radius server host
This command is used to configure the RADIUS authentication and accounting server.
If you use the parameter, the command configures the IP address to use to
connect to a RADIUS authentication server. You can configure up to 3 servers per
RADIUS client. If the maximum number of configured servers is reached, the
command fails until you remove one of the servers by issuing the “no” form of the
command. If you use the optional parameter, the command configures the UDP
port number to use when connecting to the configured RADIUS server. The
number range is 1 - 65535, with 1812 being the default value.
NOTE: To re-configure a RADIUS authentication server to use the default
UDP , set the parameter to 1812.
If you use the token, the command configures the IP address to use for the
RADIUS accounting server. You can only configure one accounting server. If an
accounting server is currently configured, use the “no” form of the command to
remove it from the configuration. The IP address you specify must match that of a
previously configured accounting server. If you use the optional parameter, the
command configures the UDP port to use when connecting to the RADIUS accounting
server. If a is already configured for the accounting server, the new
replaces the previously configured . The must be a value in the range 1
- 65535, with 1813 being the default.
NOTE: To re-configure a RADIUS accounting server to use the default UDP
, set the parameter to 1813.
Format
radius server host
{auth | acct} []
Mode Global Config
5.8.2.1 no radius server host
This command is used to remove the configured RADIUS authentication server or the
RADIUS accounting server. If the 'auth' token is used, the previously configured
RADIUS authentication server is removed from the configuration. Similarly, if the
'acct' token is used, the previously configured RADIUS accounting server is removed
from the configuration. The parameter must match the IP address of the
previously configured RADIUS authentication / accounting server.