Kontron AT8402 CLI - Manual (Page 174)

Utility Commands AT8402
AT8402 CLI Reference Manual Page 4 - 34
4.8.6 hardware-address
This command specifies the hardware address of a DHCP client. Hardware-address is
the MAC address of the hardware platform of the client consisting of 6 bytes in dotted
hexadecimal format. Type indicates the protocol of the hardware platform. It is 1 for 10
MB Ethernet and 6 for IEEE 802.
Default ethernet
Format
hardware-address
Mode DHCP Pool Config
4.8.6.1 no hardware-address
This command removes the hardware address of the DHCP client.
Format
no hardware-address
Mode DHCP Pool Config
4.8.7 host
This command specifies the IP address and network mask for a manual binding to a
DHCP client. Address and Mask are valid IP addresses; each made up of four decimal
bytes ranging from 0 to 255. IP address 0.0.0.0 is invalid. The prefix-length is an
integer from 0 to 32
Default none
Format
host
Mode DHCP Pool Config
4.8.7.1 no host
This command removes the IP address of the DHCP client.
Format no host
Mode DHCP Pool Config
4.8.8 lease
This command configures the duration of the lease for an IP address that is assigned
from a DHCP server to a DHCP client. The overall lease time should be between 1-
86400 minutes. If you specify infinite, the lease is set for 60 days. You can also specify
a lease duration. Days is an integer from 0 to 59. Hours is an integer from 0 to 1439.
Minutes is an integer from 0 to 86399.
Default 1 (day)
Format lease [{ [] [] | infinite}]
Mode DHCP Pool Config