Kontron AT8402 CLI - Manual (Page 40)

Switching Commands AT8402
AT8402 CLI Reference Manual Page 2 - 8
2.2.5 spanning-tree edgeport
This command specifies that this port is an Edge Port within the common and internal
spanning tree. This allows this port to transition to Forwarding State without delay.
Format spanning-tree edgeport
Mode Interface Config
2.2.5.1 no spanning-tree edgeport
This command specifies that this port is not an Edge Port within the common and
internal spanning tree.
Format
no spanning-tree edgeport
Mode Interface Config
2.2.6 spanning-tree forceversion
This command sets the Force Protocol Version parameter to a new value. Use 802.1d to
specify that the switch transmits ST BPDUs rather than MST BPDUs (IEEE 802.1d
functionality supported). Use 802.1w to specify that the switch transmits RST BPDUs
rather than MST BPDUs (IEEE 802.1w functionality supported). Use 802.1s to specify
that the switch transmits MST BPDUs (IEEE 802.1s functionality supported).
Default 802.1s
Format
spanning-tree forceversion <802.1d | 802.1s | 802.1w>
Mode Global Config
2.2.6.1 no spanning-tree forceversion
This command sets the Force Protocol Version parameter to the default value.
Format
no spanning-tree forceversion
Mode Global Config
2.2.7 spanning-tree forward-time
This command sets the Bridge Forward Delay parameter to a new value for the
common and internal spanning tree. The forward-time value is in seconds within a
range of 4 to 30, with the value being greater than or equal to “(Bridge Max Age / 2) +
1”.
Default 15
Format
spanning-tree forward-time <4-30>
Mode Global Config
2.2.7.1 no spanning-tree forward-time
This command sets the Bridge Forward Delay parameter for the common and internal
spanning tree to the default value.
Format no spanning-tree forward-time