Kontron AT8402 CLI - Manual (Page 54)

Switching Commands AT8402
AT8402 CLI Reference Manual Page 2 - 22
2.3.13.1 no vlan port tagging all
This command configures the tagging behavior for all interfaces in a VLAN to
disabled. If tagging is disabled, traffic is transmitted as untagged frames. The ID is a
valid VLAN identification number.
Format no vlan port tagging all
Mode Global Config
2.3.14 vlan protocol group
This command adds protocol-based VLAN groups to the system. The <
groupName>
is
a character string of 1 to 16 characters. When it is created, the protocol group will be
assigned a unique number that will be used to identify the group in subsequent
commands.
Format
vlan protocol group
Mode Global Config
2.3.15 vlan protocol group add protocol
This command adds the to the protocol-based VLAN identified by
. A group may have more than one protocol associated with it. Each
interface and protocol combination can only be associated with one group. If adding a
protocol to a group causes any conflicts with interfaces currently associated with the
group, this command fails and the protocol is not added to the group. The possible
values for protocol are
ip, arp,
and
ipx
.
NOTE: FASTPATH software supports IPv4 protocol-based VLANs.
Default none
Format
vlan protocol group add protocol
Mode Global Config
2.3.15.1 no vlan protocol group add protocol
This command removes the < protocol> from this protocol-based VLAN group that is
identified by this <
groupid>
. The possible values for protocol are
ip, arp,
and
ipx
.
Format no vlan protocol group add protocol
Mode Global Config
2.3.16 vlan protocol group remove
This command removes the protocol-based VLAN group that is identified by this
.
Format
vlan protocol group remove
Mode Global Config