Kontron AT8402 CLI - Manual (Page 145)

AT8402 Utility Commands
Page 4 - 5 AT8402 CLI Reference Manual
• pci-rst-hs: If the PCIE-reset capability is enabled, the PCIE infrastructure is set
into reset if AMC in upstream-port is deactivated.
• pci-rst-cfg: If the PCIE-configuration setting is enabled, the PCIE switch will be
reset if configuration is changed.
Format set board fcap handle enable
set board fcap handle disable
set board fcap pci-rst-hs enable
set board fcap pci-rst-hs disable
set board fcap pci-rst-cfg enable
set board fcap pci-rst-cfg disable
Mode Privileged EXEC
4.2.5 show atca ekeying
This command displays the current ekeying status together with admin mode and link
status for all interfaces
Format
show atca ekeying all
Mode Privileged EXEC
4.2.6 ekeying (interface)
This command enables the ekeying for one port. Default is enabled.
Format
ekeying
Mode Interface Config
4.2.6.1 no ekeying (interface)
This command disables the ekeying for one port. Default is enabled.
Format
no ekeying
Mode Interface Config
4.2.7 set board bootcycle
This command activates/deactivates a bootcycle-detection and (if activated) sets the
related parameters. Parameter ‘none’ deactivates the bootcycle detection. Parameters
‘event’ and ‘pwr-down’ activate the bootcycle detection and execute an action if the
number of , checked in seconds, is reached. The executed action is
the generation of an event and additionally for ‘pwr-down’ switch off the Power-PC.
Format
set board bootcycle none
set board bootcycle event
set board bootcycle pwr-down
Mode Priviliged EXEC
4.3 System Information and Statistics Commands
This section describes the commands you use to view information about system
features, components, and configurations.