Kontron AT8402 CLI - Manual (Page 177)

AT8402 Utility Commands
Page 4 - 37 AT8402 CLI Reference Manual
Format
next-server
Mode DHCP Pool Config
4.8.14.1 no next-server
This command removes the boot server list.
Format
no next-server
Mode DHCP Pool Config
4.8.15 option
The
option
command configures DHCP Server options. The <code> parameter
specifies the DHCP option code and ranges from 1-254. The parameter
specifies an NVT ASCII character string. ASCII character strings that contain white
space must be delimited by quotation marks. The hex parameter specifies
hexadecimal data. In hexadecimal, character strings are two hexadecimal digits. You
can separate each byte by a period (for example, a3.4f.22.0c), colon (for example,
a3:4f:22:0c), or white space (for example, a3 4f 22 0c).
Default none
Format
option
{ascii string | hex
[...] | ip
[...]}
Mode DHCP Pool Config
4.8.15.1 no option
This command removes the DHCP Server options. The <code> parameter specifies the
DHCP option code.
Format no option
Mode DHCP Pool Config
4.8.16 ip dhcp excluded-address
This command specifies the IP addresses that a DHCP server should not assign to
DHCP clients. Low-address and high-address are valid IP addresses; each made up of
four decimal bytes ranging from 0 to 255. IP address 0.0.0.0 is invalid.
Default none
Format
ip dhcp excluded-address
[highaddress]
Mode Global Config
4.8.16.1 no ip dhcp excluded-address
This command removes the excluded IP addresses for a DHCP client. Low-address and
high-address are valid IP addresses; each made up of four decimal bytes ranging from
0 to 255. IP address 0.0.0.0 is invalid.
Format
no ip dhcp excluded-address
[highaddress]