Kontron AT8402 CLI - Manual (Page 117)

AT8402 Quality of Service (QoS) Commands
Page 3 - 5 AT8402 CLI Reference Manual
Format
show classofservice dot1p-mapping
[<slot/port>]
Mode Privileged EXEC
The following information is repeated for each user priority.
User Priority The 802.1p user priority value.
Traffic Class The traffic class internal queue identifier to which the user priority
value is mapped.
3.1.8 show classofservice ip-precedence-mapping
This command displays the current IP Precedence mapping to internal traffic classes
for a specific interface. The slot/port parameter is optional and is only valid on
platforms that support independent per-port class of service mappings. If specified, the
IP Precedence mapping table of the interface is displayed. If omitted, the most recent
global configuration settings are displayed.
Format
show classofservice ip-precedence-mapping
[<slot/port>]
Mode Privileged EXEC
The following information is repeated for each user priority.
IP Precedence The IP Precedence value.
Traffic Class The traffic class internal queue identifier to which the IP Precedence
value is mapped.
3.1.9 show classofservice ip-dscp-mapping
This command displays the current IP DSCP mapping to internal traffic classes for the
global configuration settings.
Format
show classofservice ip-dscp-mapping
Mode Privileged EXEC
The following information is repeated for each user priority.
IP DSCP
The IP DSCP value.
Traffic Class The traffic class internal queue identifier to which the IP DSCP value
is mapped.
3.1.10 show classofservice trust
This command displays the current trust mode setting for a specific interface. The
< slot/port > parameter is optional and is only valid on platforms that support
independent per-port class of service mappings. If you specify an interface, the
command displays the port trust mode of the interface. If you do not specify an
interface, the command displays the most recent global configuration settings.
Format
show classofservice trust
[<slot/port>]
Mode Privileged EXEC
Non-IP Traffic Class The traffic class used for non-IP traffic. This is only displayed
when the COS trust mode is set to trust IP Precedence or IP DSCP (on
platforms that support IP DSCP).