11 dot1x re-authentication, 12 dot1x system-auth-control, 13 dot1x timeout – Kontron AT8402 CLI User Manual
Page 73: At8402 switching commands

AT8402
Switching Commands
Page 2 - 41
AT8402 CLI Reference Manual
2.10.11
dot1x re-authentication
This command enables re-authentication of the supplicant for the specified port.
Default
disabled
Format
dot1x re-authentication
Mode
Interface Config
2.10.11.1
no dot1x re-authentication
This command disables re-authentication of the supplicant for the specified port.
Format
no dot1x re-authentication
Mode
Interface Config
2.10.12
dot1x system-auth-control
Use this command to enable the dot1x authentication support on the switch. While
disabled, the dot1x configuration is retained and can be changed, but is not activated.
Default
disabled
Format
dot1x system-auth-control
Mode
Global Config
2.10.12.1
no dot1x system-auth-control
This command is used to disable the dot1x authentication support on the switch.
Format
no dot1x system-auth-control
Mode
Global Config
2.10.13
dot1x timeout
This command sets the value, in seconds, of the timer used by the authenticator state
machine on this port. Depending on the token used and the value (in seconds) passed,
various timeout configurable parameters are set. The following tokens are supported.
reauth-period - The value, in seconds, of the timer used by the authenticator state
machine on this port to determine when re-authentication of the supplicant takes place.
The reauth-period must be a value in the range 1 - 65535.
quiet-period - The value, in seconds, of the timer used by the authenticator state
machine on this port to define periods of time in which it will not attempt to acquire a
supplicant. The quiet-period must be a value in the range 0 - 65535.
tx-period - The value, in seconds, of the timer used by the authenticator state machine
on this port to determine when to send an EAPOL EAP Request/Identity frame to the
supplicant. The quiet-period must be a value in the range 1 - 65535.
supp-timeout - The value, in seconds, of the timer used by the authenticator state
machine on this port to timeout the supplicant. The supp-timeout must be a value in the
range 1 - 65535.