Kontron AT8402 CLI - Manual (Page 169)

AT8402 Utility Commands
Page 4 - 29 AT8402 CLI Reference Manual
4.7.2.1 no sntp client mode
This command disables Simple Network Time Protocol (SNTP) client mode.
Format
no sntp client mode
Mode Global Config
4.7.3 sntp client port
This command sets the SNTP client port id to a value from 1-65535.
Default 123
Format
sntp client port
Mode Global Config
4.7.3.1 no sntp client port
This command resets the SNTP client port back to its default value.
Format
no sntp client port
Mode Global Config
4.7.4 sntp unicast client poll-interval
This command sets the poll interval for SNTP unicast clients in seconds as a power of
two where can be a value from 6 to 16.
Default 6
Format
sntp unicast client poll-interval
Mode Global Config
4.7.4.1 no sntp unicast client poll-interval
This command resets the poll interval for SNTP unicast clients to its default value.
Format
no sntp unicast client poll-interval
Mode Global Config
4.7.5 sntp unicast client poll-timeout
This command will set the poll timeout for SNTP unicast clients in seconds to a value
from 1-30.
Default 5
Format
sntp unicast client poll-timeout
Mode Global Config
4.7.5.1 no sntp unicast client poll-timeout
This command will reset the poll timeout for SNTP unicast clients to its default value.
Format
no sntp unicast client poll-timeout
Mode Global Config