Kontron AT8402 CLI - Manual (Page 142)

Utility Commands AT8402
AT8402 CLI Reference Manual Page 4 - 2
4. Utility Commands
This chapter describes the utility commands available in the CLI.
The FASTPATH Utility Commands chapter includes the following sections:
• 4.1 “Commands for update and startup Configuration“ on page 4 - 2
• 4.2 “ATCA commands“ on page 4 - 4
• 4.3 “System Information and Statistics Commands“ on page 4 - 5
• 4.4 “Logging Commands“ on page 4 - 19
• 4.5 “System Utility and Clear Commands“ on page 4 - 24
• 4.6 “Keying for Advanced Features“ on page 4 - 27
• 4.7 “Simple Network Time Protocol (SNTP) Commands“ on page 4 - 28
• 4.8 “DHCP Server Commands“ on page 4 - 32
• 4.9 “DHCP Filtering“ on page 4 - 42
• 4.10 “Serviceability Packet Tracing Commands“ on page 4 - 43
The commands in this chapter are in one of four functional groups:
• Show commands display switch settings, statistics, and other information.
• Configuration commands configure features and options of the switch. For every
configuration command, there is a show command that displays the configuration
setting.
• Copy commands transfer or save configuration and informational files to and from
the switch.
• Clear commands clear some or all of the settings to factory defaults.
4.1 Commands for update and startup Configuration
The following commands are implemented to manipulate the Software images and
configurations of the AT8402. The slot number () ranges from 0 - 9.
4.1.1 download ipmifw
This command copies an IPMI firmware image from URL and flashes the IPMC with
the new image. If the flash process is interrupted or fails, the IPMC will automatically
recover and use the previously installed image
Format
download ipmifw
Modes Privileged EXEC
4.1.2 download initrd
This command copies an initrd tgz (including kernel) from source-url and flash it to A
or B location
Format
download initrd {A | B}
Modes Privileged EXEC
4.1.3 download frudata
This command restores the factory defaults for the FRU data.
Format
download frudata factory-default