Kontron AT8402 CLI - Manual (Page 143)

AT8402 Utility Commands
Page 4 - 3 AT8402 CLI Reference Manual
Modes Privileged EXEC
4.1.4 download fwum
This command updates the FWUM firmware. It downloads an FWUM firmware image
from URL and flashes the FWUM with the new image. If the flash process is
interrupted or fails, the FWUM will not recover gracefully and the board has to be
repaired manually.
Use this command with extreme care. It is not field safe.
Do not interrupt the upgrade process.
Format
download fwum
Modes Privileged EXEC
4.1.5 download bootloader
This command loads a bootloader image into the second partition. It downloades a
bootloader image from . This image is used for the next boot process. If the
download fails or the image is not correct (CRC error) the image in the first parttion is
used.
Format
download bootloader
Modes Privileged EXEC
4.1.6 download amcipmifw
This command updates the IPMI firmware on an AMC. It downloads an IPMI
firmware image from URL and flashes the MMC on the AMC with the new image. If
the flash process is interrupted or fails, the MMC will automatically recover and use
the previously installed image.
Format
download amcipmifw
Mode Privileged Exec
4.1.7 startupslot
This command configures the startup slot with the supplied values from the other slots.
It will also check the configuration for consistency and flag any errors. The slot
number () ranges from 0 - 9.
Format
startupslot config initrd
Mode Global Config
4.1.8 startupslot activate
This command sets the startup slot to active and will use this in all subsequent reboots.
Using [once] at the end of the command will set the startup slot to be used once during
the next restart. The start sequence will reset the startup slot to the previously installed
one. This enables a try-once with automatic rollback in case of error.
Format
startupslot activate
[once]
Mode Global Config