Kontron AT8402 CLI - Manual (Page 161)

AT8402 Utility Commands
Page 4 - 21 AT8402 CLI Reference Manual
keywords:
emergency
(0),
alert
(1),
critical
(2),
error
(3),
warning
(4),
notice
(5),
info
(6), or
debug
(7).
Default disabled; critical when enabled
Format
logging console
[severitylevel]
Mode Global Config
4.4.4.1 no logging console
This command disables logging to the console.
Format
no logging console
Mode Global Config
4.4.5 logging host
This command enables logging to a host. You can configure up to eight hosts. The
is the IP address of the logging host. The value is a port number
from 1 to 65535. You can specify the value as either an integer from 0
to 7 or symbolically through one of the following keywords:
emergency (0), alert (1),
critical (2), error (3), warning (4), notice (5), info (6), or debug (7).
Default port—514
level—critical (2)
Format logging host [][]
Mode Global Config
4.4.6 logging host remove
This command disables logging to host. See 4.4.11 “show logging hosts“ on page 4 -
23 for a list of host indexes.
Format
logging host remove
Mode Global Config
4.4.7 logging port
This command sets the local port number of the LOG client for logging messages. The
can be in the range from 1 to 65535.
Default 514
Format logging port
Mode Global Config
4.4.7.1 no logging port
This command resets the local logging port to the default.
Format
no logging port
Mode Global Config