Kontron AT8402 CLI - Manual (Page 133)

AT8402 Quality of Service (QoS) Commands
Page 3 - 21 AT8402 CLI Reference Manual
3.7.1 mac access-list extended
This command creates a MAC Access Control List (ACL) identified by ,
consisting of classification fields defined for the Layer 2 header of an Ethernet frame.
The parameter is a case-sensitive alphanumeric string from 1 to 31 characters
uniquely identifying the MAC access list.
If a MAC ACL by this name already exists, this command enters Mac-Access-List
config mode to allow updating the existing MAC ACL.
NOTE: The CLI mode changes to Mac-Access-List Config mode when you
successfully execute this command.
Format
mac access-list extended
Mode Global Config
3.7.1.1 no mac access-list extended
This command deletes a MAC ACL identified by from the system.
Format
no mac access-list extended
Mode Global Config
3.7.2 mac access-list extended rename
This command changes the name of a MAC Access Control List (ACL). The
parameter is the name of an existing MAC ACL. The parameter is a case-
sensitive alphanumeric string from 1 to 31 characters uniquely identifying the MAC
access list.
This command fails if a MAC ACL by the name already exists.
Format
mac access-list extended rename
Mode Global Config
3.7.3 {deny | permit}
This command creates a new rule for the current MAC access list. Each rule is
appended to the list of configured rules for the list.
NOTE: The 'no' form of this command is not supported, since the rules within
a MAC ACL cannot be deleted individually. Rather, the entire MAC
ACL must be deleted and re-specified.
NOTE: An implicit 'deny all' MAC rule always terminates the access list.
NOTE: Assign-queue attributes are configurable for a deny rule, but they have
no operational effect.
A rule may either deny or permit traffic according to the specified classification fields.
At a minimum, the source and destination MAC value must be specified, each of which
may be substituted using the keyword any to indicate a match on any value in that
field. The remaining command parameters are all optional, but the most frequently
used parameters appear in the same relative order as shown in the command format.