Kontron AT8402 CLI - Manual (Page 102)

Switching Commands AT8402
AT8402 CLI Reference Manual Page 2 - 70
Mode Global Config
2.17.3.1 no lldp timers
Use this command to return any or all timing parameters for local data transmission on
ports enabled for LLDP to the default values.
Format
no lldp timers
[interval] [hold] [reinit]
Mode Global Config
2.17.4 lldp transmit-tlv
Use this command to specify which optional type length values (TLVs) in the 802.1AB
basic management set are transmitted in the LLDPDUs. Use
sys-name
to transmit the
system name TLV. To configure the system name, see 5.6.1 “snmp-server“on page 5 -
15. Use
sys-desc to transmit the system description TLV. Use sys-cap to transmit the
system capabilities TLV. Use
port-desc
to transmit the port description TLV. To
configure the port description, see 2.1.4 “description“on page 2 - 3.
Default no optional TLVs are included
Format lldp transmit-tlv [sys-desc] [sys-name] [sys-cap] [port-desc]
Mode Interface Config
2.17.4.1 no lldp transmit-tlv
Use this command to remove an optional TLV from the LLDPDUs. Use the command
without parameters to remove all optional TLVs from the LLDPDU.
Format
no lldp transmit-tlv
[sys-desc] [sys-name] [sys-cap] [port-desc]
Mode Interface Config
2.17.5 lldp transmit-mgmt
Use this command to include transmission of the local system management address
information in the LLDPDUs.
Format lldp transmit-mgmt
Mode Interface Config
2.17.5.1 no lldp transmit-mgmt
Use this command to include transmission of the local system management address
information in the LLDPDUs. Use this command to cancel inclusion of the
management information in LLDPDUs.
Format
no lldp transmit-mgmt
Mode Interface Config
2.17.6 lldp notification
Use this command to enable remote data change notifications.
Default disabled