Kontron AT8402 CLI - Manual (Page 194)

Management Commands AT8402
AT8402 CLI Reference Manual Page 5 - 4
Mode Privileged EXEC
5.1.7.1 no network mac-type
This command resets the value of MAC address to its default.
Format
no network mac-type
Mode Privileged EXEC
5.1.8 show network
This command displays configuration settings associated with the switch's network
interface. The network interface is the logical interface used for in-band connectivity
with the switch via any of the switch's front panel ports. The configuration parameters
associated with the switch's network interface do not affect the configuration of the
front panel ports through which traffic is switched or routed.
Format
show network
Modes Privileged EXEC
User EXEC
IP Address The IP address of the interface. The factory default value is 0.0.0.0
Subnet Mask The IP subnet mask for this interface. The factory default value is
0.0.0.0
Default Gateway The default gateway for this IP interface. The factory default value
is 0.0.0.0
Burned In MAC Address The burned in MAC address used for in-band connectivity.
Locally Administered MAC Address If desired, a locally administered MAC
address can be configured for in-band connectivity. To take effect,
'MAC Address Type' must be set to 'Locally Administered'. Enter the
address as twelve hexadecimal digits (6 bytes) with a colon between
each byte. Bit 1 of byte 0 must be set to a 1 and bit 0 to a 0, i.e. byte 0
should have the following mask 'xxxx xx10'. The MAC address used
by this bridge when it must be referred to in a unique fashion. It is rec-
ommended that this be the numerically smallest MAC address of all
ports that belong to this bridge. However it is only required to be
unique. When concatenated with dot1dStpPriority a unique
BridgeIdentifier is formed which is used in the Spanning Tree Proto-
col.
MAC Address Type The MAC address should be used for in-band connectivity. The
choices are the burned in or the Locally Administered address. The
factory default is to use the burned in MAC address.
Network Configuration Protocol Current The network protocol is being used. The
options are bootp | dhcp | none.
5.1.9 show serviceport
This command displays service port configuration information.
Format
show serviceport