Dynojet 250iPX: Installation Guide - Manual (Page 80)

In Ground Model 200iPX/250iPX Motorcycle Dynamometer Installation Guide
C H A P T E R 2
Junction Box Cover, Cable Cover, and End Cap
2-58
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
JUNCTION BOX COVER, CABLE COVER, AND END CAP
Before installing the junction box cover, cable cover, and end cap be sure to route all
of your cables.
You will need the following parts:
• 21228517 Cable Routing Cover
• 21228519 Cable Channel End Cap
• 21228521 Junction Box Cover
• 21626902 Cable Cover, Pit to Junction Box
• 36540643 Screw, 8-32 x 3/8", Pan-Head, Phil (13)
1 Secure the junction box cover to the junction box using two 8-32 x 3/8-inch pan-
head screws.
2 Secure the end cap to the pit cover using two 8-32 x 3/8-inch pan-head screws.
3 Secure the cable cover to the end cap using four 8-32 x 3/8-inch pan-head screws.
4 Secure the cable cover to the junction box cover using one 8-32 x 3/8-inch pan-
head screw.
Note: Verify the cables are placed inside the cable cover.
5 Secure the cable routing cover to the middle pit cover using four 8-32 x 3/8-inch
pan-head screws.
Figure 2-48: Install the Junction Box Cover, End Cap, and Cable Cover
PD141
junction box cover
cable cover
end cap
cable routing
cover