Dynojet 250iPX: Installation Guide - Manual (Page 152)

In Ground Model 200iPX/250iPX Motorcycle Dynamometer Installation Guide
A P P E N D I X E
Dyno Preparation
E-2
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
DYNO PREPARATION
Use the following instructions to prepare the dyno for installing the upgrade kit.
R EMOVING THE C ABLE C OVER , E ND C AP , AND J UNCTION B OX C OVER
1 Remove the four 8-32 screws securing the cable cover to the end cap and
one 8-32 screw securing the cable cover to the junction box and set aside.
2 Remove the cable cover and set aside.
3 Remove the two 1/4-20 button-head screws securing the end cap to the pit cover
and set aside.
4 Remove the end cap and set aside.
Figure E-1: Remove the Cable Cover and End Cap
PD042
end cap
cable cover