beautypg.com

Removing the carriage and carriage plate – Dynojet 250iPX: Installation Guide User Manual

Page 157

background image

D Y N O P R E P A R A T I O N F O R U P G R A D E I N S T A L L A T I O N

Dyno Preparation

Version 2

In Ground Model 200iPX/250iPX Motorcycle Dynamometer Installation Guide

E-7

R

EMOVING

THE

C

ARRIAGE

AND

C

ARRIAGE

P

LATE

1

Remove the four 1/4-20 x 1/2-inch button-head flange bolts securing the bearing
bracket and set aside.

2

Using the control panel to run the power carriage, run the carriage screw out of
the carriage assembly and set aside.

3

Slide the carriage assembly towards the rear of the dyno. Remove the carriage
assembly and set aside.

Figure E-6: Remove the Carriage

TC053

bearing bracket

carriage

This manual is related to the following products:
See also other documents in the category Dynojet Equipment: