Dynojet 250iPX: Installation Guide - Manual (Page 19)

S P E C I F I C A T I O N S A N D O P E R A T I N G R E Q U I R E M E N T S
Dynamometer Specifications and Requirements
Version 2 In Ground Model 200iPX/250iPX Motorcycle Dynamometer Installation Guide
1-9
G ROUND H OOK R EQUIREMENTS
You may wish to install additional ground hooks (included with your dyno) for
securing the motorcycle. The tie-down loops on the pit covers should work for most
motorcycles. If you are running motorcycles that require a different tie-down location,
mount the ground hooks accordingly.
Note: Tie-down straps MUST pull the motorcycle forward.
Using the ground hooks as a pattern, use the hardware included with the ground
hook kit to install the Red Head anchors according to the instructions in Appendix A.
P HONE AND I NTERNET A CCESS
Dynojet recommends you have a phone close to the dyno to call for assistance in an
emergency. You may also wish to contact Dynojet to troubleshoot your dyno.
Internet access on your computer is desirable for contacting Dynojet and
downloading new information and updates.
T IE -D OWN S TRAPS
Dynojet recommends using motorcycle tie-down straps for securing the bike on the
dyno. You will need to provide the tie-down straps.