Dynojet 250iPX: Installation Guide - Manual (Page 43)

I N S T A L L A T I O N
Left Side Blower and Monitor Arm Installation
Version 2 In Ground Model 200iPX/250iPX Motorcycle Dynamometer Installation Guide
2-21
I NSTALLING THE M ONITOR S UPPORT AND THE J UNCTION B OX
1 Place the blower mount where you installed the Red Head anchors on page 2-20.
2 Secure the blower mount, monitor support arm, and junction box to the pit floor
using four 3/8 x 1-inch bolts and four washers.
Note: The left blower mount is secured under the support arm.
3 Verify the blank plate is secured to the junction box as shown in Figure 2-13.
4 Verify the fan connectors are secured to the junction box in the location shown in
Figure 2-13.
Figure 2-13: Install the Monitor Support Arm and Junction Box
PD113
support arm
junction box blower mount
(under support arm)
fan connectors blank plate