Dynojet 250iPX: Installation Guide - Manual (Page 39)

I N S T A L L A T I O N
Secure the Drum and Brake Module to the Pit Floor
Version 2 In Ground Model 200iPX/250iPX Motorcycle Dynamometer Installation Guide
2-17
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
SECURE THE DRUM AND BRAKE MODULE TO THE PIT FLOOR
Dynojet recommends you secure your drum and brake modules to the pit floor in
your dyno room using concrete anchors. You will want to drill the holes and secure
the dyno before placing the covers on your dyno.
Note: You may wish to drill the holes for the left and right blower mounts along
with the trike adapter mounting plate this time. Refer to page 2-19 for the left
blower mount instructions, page 2-24 for the trike adapter mounting plate
instructions, and page 2-25 for the right blower mount instructions.
You will need the following parts:
• 37513200 Anchor, Redhead, 3/8" (8)
• DM150-002-007 Washer, 5/16", Flat (8)
• DM150-019-012 Bolt, 3/8-16 x 1", Hex (8)
1 Mark and drill each hole needed to secure the drum and brake modules to the pit
floor.
2 Install the Red Head anchors. Refer to Appendix A for installation instructions.
Figure 2-10: Secure the Drum and Brake Module to the Pit Floor
PD143
drill holes
drill holes
drill holes
drill holes