Dynojet 250iPX: Installation Guide - Manual (Page 15)

S P E C I F I C A T I O N S A N D O P E R A T I N G R E Q U I R E M E N T S
Dynamometer Specifications and Requirements
Version 2 In Ground Model 200iPX/250iPX Motorcycle Dynamometer Installation Guide
1-5
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
DYNAMOMETER SPECIFICATIONS AND REQUIREMENTS
The following specifications and requirements will help you set up your dyno area
and verify you have the requirements to operate your dyno safely.
B ATTERY R EQUIREMENTS
Your 200iPX/250iPX dyno is designed to carry a group 24 deep-cycle discharge series
battery for operating the starter, power carriage, and optional wheel clamp. The
typical dimensions for this series of batteries are 27 cm long by 17 cm wide by 23 cm
tall (10.625-inches by 6.75-inches by 9.125-inches). The mounting is flexible so a
battery that has dimensions close to this will work satisfactorily. The built-in battery
cables are configured for top-post batteries. This battery is not included with your
dyno. You will need to provide this battery. For more information on installing the
battery, refer to “Installing the Battery” on page 2-31.
C HASSIS S PECIFICATIONS
description specifications
Length
with standard carriage allow 304.80 cm (120.00 in.)
with extended carriage allow 355.60 cm (140.00 in.)
iPX drum module 76.20 cm (30.00 in.)
pit covers 137.16 cm (54.00 in.)
Height
from bottom of dyno to top of dyno 45.72-46.67 cm (18.00-18.38 in.)
from top of pit to drum guard 5.40 cm (2.13 in.)
from top of pit to top of tire carriage 50.64 cm (16.00 in.)
Width
dyno with upgrade 271.42 cm (106.86 in.)
pit covers with eddy current brake 310.29 cm (122.16 in.)
Weight
model 200iP drum module/crated dyno 725 kg (1600 pounds)/817 kg (1800 pounds)
model 250iP retarder module/crated dyno 953 kg (2100 pounds)/1,089 kg (2400 pounds)
200iPX/250iPX drum module/crated 136 kg (300 pounds)/363 kg (800 pounds)
Drum
diameter 45.72 cm (18.00 in.)
width 50.80 cm (20.00 in.)
diameter, 200iPX/250iPX upgrade 45.72 cm (18.00 in.)
width, 200iPX/250iPX upgrade 55.88 cm (22.00 in.)
Frame structural steel
Maximum Speed 322 KPH (200 MPH)
Maximum Motorcycle Length (front of front
wheel to center of rear wheel)
standard carriage 213.00 cm (84.00 in.)
extended carriage 256.54 cm (101.00 in.)
Remote Switches remote software control