Dynojet 250iPX: Installation Guide - Manual (Page 72)

In Ground Model 200iPX/250iPX Motorcycle Dynamometer Installation Guide
C H A P T E R 2
Pit Covers Installation
2-50
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
PIT COVERS INSTALLATION
Use the following instructions to install the pit covers.
You will need the following parts:
• 21200025 Drum Guard Mounting Bracket, iPX module
• 21200038 Drum Safety Cover
• 21226105 Left Pit Cover
• 21226106 Eddy Current Brake Pit Cover
• 21229106 Drum Guard, iPX module (2)
• 21229111 Drum Guard, Dyno Module (2)
• 21624103 Drum Guard Mounting Bracket, Dyno Module
• 36561045 Screw, 1/4-20 x 5/8", Pan-Head, Torx (24)
• 36580434 Bolt, 3/8-16 x 1/2", Button-Head, Flange, Allen (18)
• 61100005 Middle Pit Cover
• 61100006 Right Pit Cover
• DM150-020-005 Nut, crush, 1/4-20 (8)
1 Place the eddy current brake cover over the brake module.
2 Loosely secure the eddy current brake cover using four 3/8-16 x 1/2-inch
button-head flange screws. Do not tighten.
Figure 2-40: Install the Eddy Current Brake Pit Cover
PD134