Dell POWEREDGE M1000E - Manual (Page 244)

Table 53. CMC Status
Item Description
Example: CMC1, CMC2 Name or Location.
No Errors If there are no errors then the message “No Errors” is
displayed, else error messages are listed. Critical errors
are listed first, followed by warnings.
Firmware Version Only displays on an active CMC. Displays Standby for the
standby CMC.
IP4 Displays current IPv4 enabled state only on an active
CMC.
IP4 Address: Only displays if IPv4 is enabled only on an active CMC.
IP6 Displays current IPv6 enabled state only on an active
CMC.
IP6 Local Address: Only displays if IPv6 is enabled only on an active CMC.
IP6 Global Address: Only displays if IPv6 is enabled only on an active CMC.
Table 54. Chassis or Enclosure Status
Item Description
User Define Name Example: “Dell Rack System”. You can set this option
through the CMC Command Line Interface (CLI) or Web
interface.
Error Messages If there are no errors then the message “No Errors” is
displayed, else error messages are listed. Critical errors
are listed first, followed by warnings.
Model Number Example "PowerEdgeM1000e".
Power Consumption Current power consumption in watts.
Peak Power Peak power consumed in watts.
Minimum Power Minimum power consumed in watts.
Ambient Temperature Current ambient temperature in degrees Celsius.
Service Tag The factory-assigned service tag.
CMC redundancy mode Non-Redundant or Redundant.
PSU redundancy mode Non-Redundant, AC Redundant, or DC Redundant.
Table 55. Fan Status
Item Description
Name/Location Example: Fan1, Fan2, and so on.
Error Messages If no error then "No Errors" is shown; otherwise error
messages are listed, critical errors first, then warnings.
244