beautypg.com

14 setup a feature, 1 change feature name, Setup a feature – Unitec POS4000/V2-Wash Select II User Manual

Page 94: Change feature name

background image

P O S 4 0 0 0

Document Number:

POS4007

68

Possible conditions if code not found:

• Issue date on ticket older than the oldest valid code: Ticket may or may not have been

used (Can not determine). If ticket is older than code age warning on ticket, note this to
the customer.

• Issue date on ticket younger than oldest valid code but older than oldest used code:
• Ticket was used, but has since rolled out of the used codes database.

Example to check code 123450:

[CMD]
[CHECK CODE]
[1][2][3][4][5]

(0 is optional)

[ENTER]

4.14 Setup a Feature

This command allows you to change the label (or name) of the features associated with each of
the cashier keys. These names are printed on tickets when codes are generated, accounting
reports, pricing reports and the system configuration report.

This command is also used to assign a postscript message to a feature at a specific price level.
For example, option 1 could be programmed to print a different postscript message when issued
at full price than when issued at discount 1 or discount 2. This allows you to have special
messages with certain discount levels.

To select the setup command, press the [CMD] key followed by the cashier key you want to
setup. Once the correct password is entered, you can scroll through the secondary menu that
follows:

• Change Wash Name
• Set Reg. Postscript
• Set Dis 1 Postscript
• Set Dis 1 Postscript
• Set Postscript All $

To execute one of the secondary commands, scroll through the secondary menu until the
command of interest is displayed, and then press the [ENTER] key.

4.14.1

Change Feature Name

To change the name (or label) of a feature, scroll through the Setup secondary menu until
"Change Wash Name" is displayed. Then press the [ENTER] key.

At this point, the top line of the display will prompt you to Enter Label Name and the second line
will display the current name of the feature. By using the alphanumeric characters on the keys,
you should type in the new name of the feature.

Warning:

If you press [ENTER] when the current name is displayed, you will change the label to
be BLANK.

Document Title:

POS4000/V2 WSII Operations Manual