5 reverse order – Unitec POS4000/V2-Wash Select II User Manual
Page 60

P O S 4 0 0 0
Document Number:
POS4007
34
Document Title:
POS4000/V2 WSII Operations Manual
[ENTER]
Note:
The default setting is 0, which is normal protocol.
4 . 1 . 1 0 . 5 R e v e r s e
O r d e r
Note:
This feature is for use with POS 1 and 2 only.
Enabling the Reverse Order function will allow the order of carwashes configured
in the External POS device to be reversed. This function is often used when the
External POS has the prices configured in descending order (wash 1 on EXTPOS
is most expensive). Since the wash prices for an entry system that uses cash
must be in ascending order at the POS4000, this function allows the re-mapping
of the washes requested at the registers and pumps. This function must be
configured w/ POS MAX WASHES to determine how to reverse the order.
Example:
Carwash is configured w/ 3 washes:
Wash 1 (program 1): Basic $4.00
Wash 2 (program 2): Deluxe $5.00
Wash 3 (program 3): Supreme $6.00
Register is configured to the opposite:
Wash 1 : Supreme $6.00
Wash 2 : Deluxe $5.00
Wash 3 : Basic $4.00
To make the system function properly you must configure POS MAX washes (See Section
4.1.10) to a value of 3 (3 washes). Set Reverse order to 1 (enabled).
After changing these values the current EXT POS settings will print out with a mapping of the
Carwash type given vs. the carwash type requested. This will show the relationship of the
mapping.
If you use groups, you must also set the POS OFFSET (Se Section 6.2.10.1).
This function only works with POS 1 & POS 2.
Example to set Reverse order to Enabled:
[CMD]
to select command mode
[2-System Setup]
to select "System Setup" menu
[3]
Enter your password 3
[ENTER]
[Menu up]
Until you see: "Ext. POS MENU->"
[Menu up]
Until you see “Reverse order”
[Enter]
Select
function